TM 5-4320-300-146-8. CYLINDER LINER (CONT)Location/ItemActionRemarksREASSEMBLY/ADJUSTMENT16. Cylinder linerRecheck cylinder liner inside diameter, taper,recheckand out-of-round as previously described. Re-place liners if necessary.CAUTIONPiston and liner damage may result if pistons are not returned to their originalliners. Observe matchmarks so that mixups do not occur.17. Piston andInsert each piston in its respective cylinder linerliner clear-or replacement liner and measure the pistonanceskirt-to-cylinder liner clearance. If clearance isnot within 0.0031 to 0.0068 inch (0.0787 to0.1727 mm), inspect pistons and replace ifnecessary.18. Cylinder linerInstall liner (new or replacement) in properwithin blockbore of cylinder block and measure insidemeasurementdiameter, out-of-round, and taper with abore gage at the locations shown in step 5.Rehone or replace liners as needed.NOTETaper on a used liner must not exceed 0.002 inch (0.0508 mm) and out-of-round mustnot exceed 0.003 inch (0.0762 mm).6-53
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
