TM 5-4320-300-14
6-6. OIL COOLER (CONT)
Location/item
Action
Remarks
CAUTION
Do not remove the oil pump drive gear unless it is damaged enough to be replaced. Equipment
malfunction may result if a used gear is reinstalled.
11. Drive gear
Reinstall crankshaft
pulley retainer bolt
and washer in the end
of crankshaft. Attach
the jaws of a suitable
gear puller behind the
gear and locate end of
puller screw in center
of pulley retainer bolt.
Turn puller screw
clockwise and remove
gear from crankshaft.
CLEANING
WARNING
Severe burns, illness, or death may result if personnel fail to handle diesel fuel properly. Observe
the following precautions:
·
Do not inhale vapor.
·
Work in a well-ventilated area.
·
Do not handle fuel near open flame, sparks, or excessive heat.
Compressed air used for cleaning shall not exceed 100 psi (690 kPa). Use goggles or face shield
for eye protection. Do not direct airstream against skin.
12. All parts
Wash in clean VV-F-800 diesel fuel and dry with compressed air.
INSPECTION
13.
Oil pump
Inspect bracket and pipe for cracks, damaged
inlet pipe
sealing surfaces, and distortion. Inspect flange
for warpage and seal surface damage. Replace
if damaged.
6-19
