TM 5-4320-300-145-9. BLOWER ASSEMBLY (CONT)Location/ItemActionRemarksREMOVAL3. BlowerRemove blower-to-block bolts and washers. Re-assemblymove blower assembly from cylinder block.INSTALLATION4. Blower-to-Apply MIL-S-45180 sealing compound to blockblock gasketside only of gasket, and position gasket on block.5. Front plate-to-Install over threaded ends of bolts. Apply MIL-S-blower gasket45180 sealing compound to front plate side ofgasket.6. BlowerPlace on cylinder block locating flanges, and sup-assemblyport while threading mounting bolts throughblower and into the engine end plate and flywheelhousing. Tighten hand tight.7. Blower-to-Torque to 10 to 15 ft lb (14 to 20 Nm).block bolts8. Center blower- Torque to 20 to 25 ft lb (27 to 34 Nm).to-front platebolts9. Top and bottom Torque to 20 to 25 ft lb (27 to 34 Nm).blower-to-frontplate bolts10.Blower-to-block Torque to 55 to 60 ft lb (75 to 81 Nm).bolts5-25
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
