TM 5-4320-300-14
5-6. STARTER MOTOR ASSEMBLY (CONT)
Location/Item
Action
Remarks
INSTALLATION
3. Main wiring
Begin at control panel and route main wiring
harness
harness, in a clockwise direction, close to its
connecting points.
NOTE
If string was used as a tracer, pull and remove string as harness is installed. Attach tie wraps as
needed to secure harness, but do not tighten them.
4. Main wiring
Connect wires to electrical components. Tighten
harness con-
terminal nuts or screws firmly, and attach plugs
necting wires
or contacts firmly. Tighten tie wraps.
5-21
