TM 5-4320-275-13 & P
DATA PLATES (CONT)
LOCATION/ITEM
ACTION
REMARKS
INSPECTION
1. Data plates
Inspect for legibility. If illegible, replace data
plate.
CLEANING
WARNING
Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes and prolonged
exposure of skin to cleaning solvent. Wash exposed skin thoroughly. Dry cleaning solvent
(fed spec P-D-680) used to clean parts is potentially dangerous to personnel and property. Do
not use near open flame or excessive heat. Flash point of solvent is 100 F (38C).
2. Data plates
Wipe data plates with a soft cloth moistened with
dry cleaning solvent, P-D-680. Wipe dry.
REMOVAL
3. Date plates
Use an electric drill with a 1/8 inch twist drill to
remove rivets holding data plate.
REPLACEMENT
4. Identification
Use blank serial plate for replacement of the iden-
plate
tification plate. Use hammer and die set to stamp
serial plate with information applicable to each
identification plate for each pump assembly.
NOTE
Where information on the identification plate is illegible, leave the block blank on the serial
plate.
5. Data plates
Use a rivet kit to install data plates on coupling
guard.
4-52
