TM 5-4320-218-15
1 Lifting bail
15
Screen
29
Valve lever
Suction manifold
43
2 Support
16
Adapter (male)
Pivot pin
30
Cam arm pin
44
3 Lockwasher
17
Stud
Cover
Cam arm
31
45
4 Hex nut
18
Cover plate
Ball
32
Cam arm ring
46
5 Gasket
19
Drain cock
Pipe connector
Dust plug gasket
33
47
6 Eliminator assembly
20
Hose clamp
Strainer body
"S" hook
34
48
7 Cap screw
21
Thin wall hose
Gasket
Chain
35
49
8 Cap screw
22
Cotter pin
Stud
Dust plug body
36
50
9 Throttle bracket
23
Screw
Gate valve
Coupler body
37
51
10 Setscrew
24
Float
Flange coupler
Pump
38
52
11 Jam nut
25
Valve collar
Cap screw
Hex nut
39
53
12 Yoke
26
Valve lever clip
Gasket
Lockwasher
40
54
13 Cover
27
Valve
Dust plug
41
Cap screw
55
14 & 14A. Gaskets
28
Valve seat
Cap screw
42
b. Cleaning and inspection.
( 3 ) securing the suction manifold
(1) C l e a n all parts with an approved
(43) to the strainer body (34). Re-
cleaning solvent and wipe dry with a
move the suction manifold.
clean lintless cloth.
(4) Unscrew jam nut (11) and setscrew
(2) Inspect the cover for cracks and
(10), and remove the yoke (12).
breaks. Replace a defective cover if
necessary.
(5) Remove the cover (13) and gasket
(14), and lift out the screen (15).
(3) Inspect the float for holes and cracks.
Replace a defective float.
(3) securing the strainer body (34) to
(4) Inspect all fittings and screws for
pump (52).
damage. Replace any defective part as
necessary.
(7) Discard all gaskets removed.
(5) Inspect all fittings and screws for
b. Cleaning and inspection.
damage, Replace any defective part as
(1) C l e a n all parts with an approved
necessary.
cleaning solvent and dry thoroughly
(6) Discard the gasket and use a new
with compressed air or a clean lintless
gasket for reassembly.
cloth.
(7) Inspect the valve and seat for wear,
(2) Inspect the suction manifold, flange
grooves, or ridges. Replace the valve
and seat as an assembly if worn or
breaks, and damage. Replace any part
damaged.
if necessary.
c. Reassembly and installation. Reverse the
(3) Inspect all studs, nuts, and bolts for
procedures outlined in a above.
stripped, worn, or damaged threads.
Replace any part if necessary.
(4) Inspect the screen for holes and dam-
a. Removal and disassembly.
age. Replace a damaged screen.
(1) Remove the screws (42), nuts (4),
a n d lockwashers (3) securing the
for damage and stripped threads, Re-
flange coupler (38) to the flange of
place a damaged coupler if necessary.
each gate valve (37).
c. Reassembly and installation. Reassemble
and install each part removed by reversing the
(3) securing the gate valves (37) to
procedures given in a above.
the suction manifold (43).