TM 5-4320-218-15
pilot to aline the line reamer in the
outside diameter of the throttle-shaft
bushing.
bushing.
(2)
(6) Turn the casting over and prepare the
With the casting still in place, set the
opposite hole to take the bushing. It
stop on the press to the length of the
will be necessary to reset the stops on
bushing. This will give the approxi-
the spindle. Counterbore the hole and
mate setting of the spindle travel.
drive the second throttle-shaft bush-
(3)
Counterbore the hole to accommodate
ing into position. Line-ream the in-
the bushing.
side diameter as before.
(4)
Drive the throttle-shaft bushing into
place, using the proper bushing driv-
88. Carburetor Reassembly
er.
Reassemble the carburetor in the reverse
(5)
Ream this bushing with the line ream-
er, using the opposite shaft hole as a