TM 5-4320-218-15
1 Dome bolt
2 Gasket
3 Dome
4 Gasket
5 Filter screen
6 Fuel head
7 Screw
8 Fuel line
9 Spring retainer
10 Valve spring
11 Valve
12 Gasket
13 Valve plate
14 Screw
15 Diaphragm
16 Gasket
17 Spring
18 Bracket
19 Linkage
20 Spring
21 Rocker arm
22 Gasket
23 Plunger cap
24 Lockwasher
25 Cap screw
26 Primer handle
27 Spring
28 Packing ring
29 Primer shaft
30 Adapter
31 Gasket
32 Plunger
33 Bushing
34 Pin
35 Lockwasher
36 Capscrew
Figure 24. Fuel pump and adapter, exploded view.
Warning: Be sure to thoroughly clean the
e. Clean the fine mesh screen thoroughly in
inside of the bowl and cover. Lay the cover
an approved cleaning solvent and wipe dry. Be
over the casting and screen, and replace the cap
careful not to bend or damage it, Set the cork
screw through the hole in the center of the
cover-plate gasket on the edge of the body cast-
cover. Tighten this screw securely. Be sure
ing. Place the screen (5) over the gasket in
the fiber gasket is in place on the cap screw.
such a way that the rim of the screen lies close
against it. The two small metal projections
near the center of the screen should face up-
ward. Replace the pulsator dome.
52
