TM 5-4320-215-12CHAPTER 3OPERATOR AND ORGANIZATIONAL MAINTENANCE INSTRUCTIONSNoteNo special tools or equipment are needed by the operator or organizational maintenancepersonnel for maintenance of this pumping unit.Section I. LUBRICATION28. General Lubrication Informationa.This section contains a reproduction of thelubrication order and lubrication instructions which aresupplemental to, and are not specifically covered in thelubrication order.b.The lubrication order shown in figure 9 is anexact reproduction of the approved lubrication order forthe pumping unit. For the current lubrication order, referto DA Pam 810-4.c.For engine lubrication, refer to TM 5-2805-209-12.29. Detailed Lubrication Informationa. Care of Lubricants.Keep all lubricants (greaseand oil) in closed containers and store in a clean, dryplace away from external heat. Allow no dirt, dust,water, or other foreign material of any kind to mix withthe lubricants. Keep all lubrication equipment clean andready for use.b. Points of Lubrication.Refer to figure 9 forillustration of the lubrication points.c. Cleaning.Keep all external parts, not requiringlubrication, clean of lubricants. Before lubricating theequipment, wipe all lubrication points free of dirt andgrease. Clean all lubrication points after lubricating toprevent accumulation of foreign matter.d. Oil Filter.For service of the oil filter, refer toTM 52805-209-12.e. Air Cleaner.For service of the air cleaner,refer to TM 5-2805-209-12.f. Wheel Bearing.For service of the wheelbearing, refer to paragraph 61.19
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
