TM 5-4320-200-13 & P
Figure 4-7 Legend.
b.
Cleaning and Inspection.
Drycleaning solvent, P-D-680, used to clean
parts is potentially dangerous to personnel
and property.
Avoid inhalation of fumes and
repeated or prolonged skin exposure.
Wash
exposed skin thoroughly with soap and water.
Use in well ventilated area away from open
flame or excessive heat.
Flash point is
100°F (38°C).
(1) Clean all parts with approved cleaning solvent and dry
thoroughly.
(2) Inspect housings, impeller, wear plate, seals, and shaft,
and shaft coupling for cracks, breaks, wear, leaky seals, and other
damage.
(3) Repair cracks and breaks in housings using approved arc
welding methods, provided repair does not upset critical pump
tolerances.
----
(4) Replace all damaged or defective parts.
4-15