TM 5-3825-270-10
OPERATOR MAINTENANCE
UNIVERSAL POWER INTERFACE KIT (UPIK) CONNECT/DISCONNECT
INITIAL SETUP:
Not Applicable
CONNECT UPIK TO PRIME MOVER FROM PRIME MOVER
1.
Load water distributor on prime mover. (TM 9-2320-364-10)
2.
Remove harness connector cap (Figure 1, Item 3) from UPIK connection point (Figure 1, Item 4).
4
1
2
3
8
7
6
5
Figure 1. Connect UPIK to Prime Mover.
3.
Remove cover (Figure 1, Item 1) from air fitting (Figure 1, Item 2).
4.
Remove cover (Figure 1, Item 8) from air line (Figure 1, Item 7).
5.
Remove connector cap (Figure 1, Item 6) from UPIK harness connector (Figure 1, Item 5).
6.
Connect air line (Figure 2, Item 7) to air fitting (Figure 2, Item 2).