TM 5-3820-276-10-2
OPERATOR MAINTENANCE
ENGINE STARTS BUT STOPS WHEN ENGINE CONTROL SWITCH RETURNS TO RUN/IDLE POSITION -
WELDER/GENERATOR
INITIAL SETUP:
References
Equipment Condition
Engine off (Volume 1, WP 0045)
TROUBLESHOOTING PROCEDURE
ENGINE STARTS BUT STOPS WHEN ENGINE CONTROL SWITCH RETURNS TO RUN/IDLE POSITION -
WELDER/GENERATOR
SYMPTOM
Engine stops when engine control switch returns to run/idle position.
MALFUNCTION
Fault is displayed.
CORRECTIVE ACTION
Refer to display for fault (Figure 1).
DISPLAY
WWDS00472
Figure 1.
Display.
a.
If NoFUEL is displayed, proceed to No FUEL (WP 0158) work package. If HI H2O is
displayed, proceed to HI H2O (WP 0159) work package. If LO OIL is displayed, proceed
to LO OIL (WP 0160) work package.