TM 10-4320-344-24
2.21.22 Air Intake Pipe Assembly Maintenance. Model 609-A.
This task covers:
2.21.22.1 Disassembly
2.21.22.3 Assembly
2 .
2
1 .2 2 . 2 R e p a ir
INITIAL SETUP
Tools
Equipment Conditions (Continued)
General Mechanic’s Automotive
Hood Assembly removed, paragraph 2.19.1.
Tool Kit, Appendix B, Section
III, Item 1
General Safety Instructions
Material/Parts
Do not work on equipment that is not
securely stabilized to prevent rolling
Gasket (TM 10-4320-344-24P)
o r s l i d i n g.
Lock Washers (TM 10-4320-344-24P)
Do not work on equipment without follow-
Equipment Conditions
ing standard shop safety practices.
Pumping station shut down, TM 10-4320-
344-10.
2.21.22.1 Disassembly.
Figure 2-137.
Air Intake Tube Assembly, Model 609-A.
a.
Loosen hose clamp (Figure 2-137,
1), remove air intake pipe (2) from rubber
elbow (3), and remove hose clamp (1).
b.
Loosen hose clamp (4) and remove rubber elbow (3) from turbine housing (5) and
hose clamp (4).
c .
Loosen hose clamp (6) that secures hose (7) to turbine housing (5) and air
intake tube (8).
Remove hose (7) and two hose clamps (6).
d.
Remove two screws (9), lock washers (10), air intake tube (8), and
gasket (11).
Discard lock washers (10) and gasket (11).
2-312
