TM 10-4320-344-24
2.16.17 Engine Alarm Reset Assembly Replacement, Model 609-A.
This task covers:
2.16.17.1 Removal
2.16.17.2 Installation
INITIAL SETUP
Tools
General Mechanics Automotive
Tool Kit, Appendix B, Section
III, Item 1
Material/Parts
Tags, Appendix C, Item 31
Lock Washers (TM 10-4320-344-24P)
Equipment Conditions
Pumping station shut down, TM
10-4320-344-10.
Battery disconnected, paragraph
2 .
1
5 .
2.
Equipment Conditions (Continued)
Control Panel Cover Assembly removed,
paragraph 2.16.1.
General Saftey Instructions
To prevent rolling or sliding, do not work
on equipment that is not securely
s t a b i l i z e d .
Do not work on equipment with battery
connected. Electrocution hazard is
present if battery is connected.
Do not work on equipment without following
standard shop safety precautions.
2.16.17.1 Removal.
Do not work on equipment with battery connected. Electrocution hazard is
present if battery is connected. Failure to obey this warning may result in
death or serious personal injury.
a.
Remove two screws (Figure 2-68, 1,), lock washers (2), and four wires (3) from
engine alarm reset (4). Tag wires (3) and discard lock washers (2).
b.
Remove screw (5), lock washer (6), and wire (7). Tag wire (7) and discard
lock washer (6).
c .
Remove screw (8), lock washer (9), and wire (10). Tag wire (10) and discard
lock washer (9).
d.
Remove nut (11), lock washer (12), and engine alarm reset (4) from control
panel (13). Discard lock washer (12).
2.16.17.2 Installation.
a .
Position engine alarm reset (4) in control panel (13) and secure with new lock
washer (12) and nut (11).
b .
Install wire (10), new lock washer (9), and screw (5). Remove and discard
t a g.
c .
Install wire (7), new lock washer (6), and screw (5). Remove and discard tag.
d.
Install four wires (3), two new lock washers (2), and screws (1). Remove and
discard tags.
2-177
