TM 10-4320-344-24
2.16.15 Engine Alarm Assembly Replacement, Model 609-A.
This task covers:
2.16.15.1 Removal
2 .
1
6 .1 5 . 2 I n s t a l l a t i o n
INITIAL SETUP
Tools
Equipment Conditions (continued)
General Mechanics Automotive
Control Panel Cover Assembly removed,
Tool Kit, Appendix B, Section
paragraph 2.16.1.
III, Item 1
General Safety Instructions
Materials/Parts
To prevent rolling or sliding, do not work
Tags, Appendix C, Item 31
on equipment that is not securely
Lock Washers (TM 10-4320-344-24P)
s t a b i l i z e d .
Equipment Conditions
Do not work on equipment with battery
connected.
Electrocution hazard is present
Pumping station shut down, TM
if battery is connected.
10-4320-344-10.
Do not work on equipment without following
Battery disconnected, paragraph
standard shop safety precautions.
2 .
1
5 .
2.
2.16.15.1 Removal.
Do not work on equipment with battery connected.
Electrocution hazard is
present if battery is connected.
Failure to obey this warning may result in
death or serious personal injury.
a .
Remove screw (Figure 2-66,
1), lock washer (2), and wire (3) from engine alarm
r e s e t ( 4 ).
Discard lock washer (2) and tag wire (3).
b .
Remove two nuts (5), wires (6), lock washers (7), and screws (8).
Tag wires
(6) and discard lock washers (7).
c .
Remove engine alarm assembly (9) from control panel (10).
2.16.15.2 Installation.
a.
Position engine alarm assembly (9) on control panel (10) and secure with two
screws (8), new lock washers (7), wires (6), and nuts (5).
Remove and discard
t a g s.
b .
Install wire (3), new lock washer (2),
( 4 ).
and screw (1) on engine alarm reset
Remove and discard tag.
2-173
