TM 10-4320-344-242.16.16 HornReplacement,ModelUS636HCCD-1.This task covers:2.16.16.1 Removal2.16.16.2 InstallationINITIAL SETUPToolsEquipmentConditions(Continued)General Mechanic’s AutomotiveControl Panel Cover Assembly removed,Tool Kit, Appendix B, SectionIII, Item 1paragraph 2.16.2.General Safety InstructionsMaterials/PartsTo prevent rolling or sliding, do not workTags, Appendix C, Item 31on equipment that is not securelyLock Washers (TM 10-4320-344-24P)stabilized.Equipment ConditionsDo not work on equipment with batteryc o n n e c t e d . E l e c t r o c u t i o n h a z a r d isPumping station shut down, TM10-4320-344-10.present if battery is connected.Do not work on equipment without followingBattery disconnected, paragraph2 .15 .4 .standard shop safety precautions.2.16.16.1 Removal.Do not work on equipment with battery connected. Electrocution hazard ispresent if battery is connected. Failure to obey this warning may result indeath or serious personal injury.a .Remove two screws (Figure 2-67, 1), locking tabs (2), and three wires (3).Tag wires.b .Remove two nuts (4), lock washers (5), screws (6), and horn (7) from controlpanel (8). Discard lock washers (5).2.16.16.2 Installation.a .Position horn (7) on control panel (8) and secure with two screws (6), newlock washers (5), and nuts (4).b .Install three wires (3) and secure with two locking tabs (2) and screws (1).Remove and discard tags.2-175
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business