Table 1-3. Description of Major Components, Model 609-C.

Figure 1-2. Location of Major Components, Model 609-C.

Figure 1-3. Location of Major Components, Model US636HCCD-1

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
6

Table 1-3. Description of Major Components, Model 609-C. Item No. 1 2 3 4 5 6 7 8 9 Item Name SOUND ENCLOSURE EXHAUST SYSTEM BATTERY STORAGE COMPARTMENT AIR INTAKE FILTER COMPARTMENT ROTATING ASSEMBLY SLING/TIE DOWN POINTS FUEL TANK AXLE AND WHEEL ASSEMBLY FORKLIFT POCKET Description and Purpose Consists of metal panels with insulation adhered to the inner surfaces. Muffles sound to reduce engine noise in the area near the operating pumping assembly. Exhaust gases are expelled through the exhaust manifold to the turbocharger. The gases are then expelled by the turbocharger through the muffler and exhaust pipes. Engine noise is reduced by passing exhaust through the muffler. Stores batteries used to provide electrical energy to the pumping assembly. Houses air intake filter used to provide filtered air to the turbo charger at atmospheric pressure. Provides the interface between the diesel engine and the water pump. The pump rotating assembly contains the impeller shaft of the pump which is supported by a single, self-lubricated, permanently sealed, ball bearing. The impeller shaft drives the impeller which causes the pump to transfer water. Tie down points are used to secure the pump assembly to transportation vehicles. The sling load paints are hard points used for sling operations. Stores diesel fuel, used to power diesel engine operation. Used to support and transport the pumping assembly. Provides access for forklift tines for lifting and moving the pumping assembly when a towing vehicle is not available. 1-6 TM 10-4320-344-24

Privacy Statement
Press Release
Contact