Table 1-2. Description of Major Components, Model 609-A.

1.14.2 Location and Description of Components.

Figure 1-2. Location of Major Components, Model 609-C.

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
4

TM 10-4320-344-24 Item No. 1 2 3 4 5 6 7 8 Table 1-2. Description of Major Components, Model 609-A. Item Name EXHAUST SYSTEM ROTATING ASSEMBLY AXLE AND WHEEL ASSEMBLY AIR INTAKE FILTER ENGINE HOOD FUEL TANK SLING/TIE DOWN POINTS RADIATOR Description and Purpose Exhaust gases are expelled through the exhaust manifold to the turbocharger. The gases are then expelled by the turbocharger through the muffler exhaust pipes and rain cap. Engine noise is reduced by passing exhaust through the muffler and rain is kept out by the rain cap. Provides the interface between the diesel engine and the water pump. The pump rotating assembly contains the impeller shaft of the pump which is supported by a single, self-lubricated, permanently sealed, ball bearing. The impeller shaft drives the impeller which causes the pump to transfer water. Used to support and transport the pumping assembly. Provides filtered air to the turbocharger at a t m o s p h e r i c p r e s s u r e. Provides protection to the diesel engine from rain, snow, and blowing debris. Stores diesel fuel; used to power diesel engine operation. Tie down points are used to secure the pump assembly to transportation vehicles. The sling load points are hard points used for sling operations. Divides engine coolant through many small thin walled tubes, which have air drawn across them by a fan, to lower engine temperature. 1-4

Privacy Statement
Press Release
Contact