TM 10-4320-344-24
e .
Replace all defective components.
2.15.9.3 Installation.
a .
b .
c .
d .
e .
f .
Position limit switch assembly (20) on limit switch mounting plate (17) and
secure with two new lock washers (19) and nuts (18).
Position limit switch mounting plate (17) on rear panel plate (21) and secure
with two bolts (16), four new lock washers (15 and 14), and nuts (13).
Install limit switch assembly wire (11), new lock washer (10), and screw (9)
on mode switch (12).
Install limit switch wire (7), new lock washer (6), and nut (5) on start alarm
r e l a y ( 8 ).
Install new electrical tiedown straps (4) on wiring harness (3) and insert
wiring harness (3) in plastic sheathing (2).
Secure plastic sheathing (2) with new electrical tiedown straps (l).
2-133
