TM 10-4320-344-24
2.12.15 Bulkhead Panel Assembly and Belt Guard Maintenance, Model 609-C.
This task covers:
2.12.15.1 Removal
2 .
1
2 .1 5 . 4 R e p a ir
2.12.15.2 Disassembly
2.12.15.5 Assembly
2.12.15.3 Inspection
2.12.15.6 Installation
INITIAL SETUP
Tools
Equipment Conditions (Continued)
General Mechanic’s Automotive
End Panel Assembly removed, paragraph
Tool Kit, Appendix B, Section
2.12.11.
III, Item 1
Straps removed, paragraph 2.12.12.
Material/Parts
Baffles removed, paragraph 2.12.13.
Lock Washers (TM 10-4320-344-24P)
Cooling Duct Assembly and Outlet Duct Frame
Equipment Conditions
Assembly removed, paragraph 2.12.14.
Pumping station shut down, TM
Air Intake Hose removed, paragraph 2.14.4.
10-4320-344-10.
General Safety Instructions
Top Panel Assembly removed,
paragraph 2.12,4.
To prevent rolling or sliding, do not work
on equipment that is not securely
Right Side Panel Assembly removed,
s t a b i l i z e d.
paragraph 2.12.6.
Do not work on equipment without following
Left Side Panel Assembly removed,
standard shop safety precautions.
paragraph 2.12.8.
2.12.15.1 Removal.
a .
Remove bolts (Figure 2-26, 1).
b .
Remove bulkhead panel assembly (2) from trailer (3).
2.12.15.2 Disassembly.
a.
Remove two screws (4), lock washers (5), flat washers (6), and right side belt
guard (7) from bulkhead panel assembly (2).
Discard lock washers (5)
b .
Remove four screws (8), four lock washers (9), four flat washers (10), and
left side belt guard (11) from bulkhead panel assembly (2). Discard lock
washers (9).
2.12.15.3 Inspection.
a.
Inspect bulkhead panel assembly (2) for deterioration or damage to insulation
material.
b .
Inspect bulk head assembly (2) and belt guards (7 and 11) for corrosion,
bends, or cracks.
2.12.15.4 Repair.
a .
Replace damaged or deteriorated insulation material on hitch side of bulkhead
panel assembly (2). Refer to Appendix D to manufacture new insulation
material.
2-76
