TM 10-4320-344-10SECTION III. OPERATION UNDER USUAL CONDITIONS2.3 ASSEMBLY AND PREPARATION FOR USE.2.3.1 Site Location.Site requirements will be based on the needs of the system inwhich the pumping assembly is to be used.The pumping assemblies are components ofa Tactical Water Distribution Equipment System (TWDS).Refer to applicable TWDStechnical manual for site requirements.When used as a source pumping station, thesite location will be determined by the location of the water source.When used asboost pumping station(s), the spacing and location(s) will be determined by theconfiguration of the line (hoseline or pipeline) to which the pumping assembly isconnected.Requirements for the TWDS hoseline are defined in applicable TWDStechnical manual.For all requirements, the site should be as level as possibleand must be capable of being traversed by the vehicle used to tow the pumpingassembly.The following procedure is applicable to all three models of the 600 GPMpumping assemblies.Procedures may vary slightly between models.2.3.2 Assembly and Preparation of Pumping Assemblies.Use a suitable vehicle to tow pumpingassembly to the installation site.Refer to Figure 2-13 and disconnect pumpingassembly from the towing vehicle as follows:Figure 2-23.Disconnecting Pumping Assembly From Towing Vehicle.a.Place park brake lever(s) (5) in lock position.b.Disconnect intervehicular cable (6) from mating receptacle (2) on towvehicle (7) .2-83N O T E
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business