TM 10-4320-325-14
TO 34Y5-2-40-1
4
5
3
2
6
1
REPAIR:
a. Remove and replace stud (5 or 6) from bolt hole, if damaged.
b. Pry last insert thread into center of hole with hook pick, and remove insert.
c.
Install new insert to a depth of 0.25 to 0.5 pitch below top surface of tapped hole in pump
casing.
d. Remove drive tank with flat punch.
INSTALLATION:
Note
If pump casing is new, paint new stencils PRIME and OUT on casing, as
shown in Figure 5-2.
a. Position pump casing to engine and install four new socket head cap screws (3), tightening in
an alternating pattern. Torque to 32-35 ft-lb (443 to 484 m-kg).
b. Deleted.
c.
Install bushing adapter (2) and drain cock (1).
Change 4
