TM 10-4320-318-14
4-19. MAINTENANCE OF NOISE ENCLOSURE.
This task covers:
a. Remove
c. Inspect
e. Assemble
b. Disassemble
d. Repair
f. Install
INITIAL SETUP
Tools
General Mechanics Tool Kit
(Item 1, Appendix B)
Riveter, Blind
(Item 2, Appendix B)
Drill, Electric, Portable 1/2 inch
Cap, with Drill Bits
(Item 2, Appendix B)
Safety Goggles
(Item 2, Appendix B)
Materials/Parts
Lockwashers (TM 10-4320-318-24P)
Rivets (TM 10-4320-318-24)
Tape, Anti-seizing
(Item 11, Appendix E)
Personnel Required
Two
General Safety Instructions
WARNING
•
Because of the weight and bulk of the noise
enclosure, a minimum of two people are required
to remove/install this equipment.
Failure to
comply with this warning could result in serious
injury to personnel and damage to equipment.
•
Eye protection shall be worn when drilling out
rivets to prevent small particles from entering the
eyes and causing serious injury.
Equipment Conditions
Muffler is removed (para. 4-16).
a.
REMOVE (Figure 4-5).
(1) Remove pipe nipples (1 and 2) from pump (5) suction and discharge ports.
(2) Remove pipe couplings (3 and 4) from pipe nipples (1 and 2).
(3) Remove nuts (6), lockwashers (7), bolts (8), flat washers (9), and bushings (10) that secure end panels
(11 and 12) to foundation frame (20).
(4) Remove nuts (13), lockwashers (14), bolts (15), flat washers (16), and bushings (17) that secure side
panels (18 and 19) to foundation frame (20).
Because of the weight and bulk of the noise enclosure, a minimum of two people
are required to remove/install this equipment. Failure to comply with this warning
could result in serious injury to personnel and damage to equipment.
(5) Lift and remove noise enclosure from foundation frame (20).
4-14
WARNING
