TM 10-4320-318-14
6-7. MAINTENANCE OF CYLINDER LINER.
This task covers:
a. Remove
c. Install
b. Inspect
INITIAL SETUP
Tools
Ring Compressor
(Item 3, Appendix B)
Inside and Outside Micrometers
(Item 3, Appendix B)
Materials/Parts
Oil, Lubricating
(Item 7, Appendix E)
Equipment Conditions
Cylinder head removed (para. 6-6).
a.
REMOVE (Figure 6-11).
Figure 6-11. Cylinder Liner
(1) Set piston at Bottom Dead Center (BDC).
(2) Slide cylinder off piston.
b. INSPECT.
(1) Inspect cylinder walls for scratches or other damage. Check for signs of overheating (scuff marks on
cylinder wall). Replace damaged cylinder.
(2) Measure cylinder bore at depth levels 1, 2, 3, and 4 (Figure 6-12) of running surface.
6-17
