TM 10-4320-318-14
6-6. MAINTENANCE OF CYLINDER HEAD - (Cont)
(c) Install O-ring (36) onto oil priming device (35).
(d) Install oil priming device (35).
(3) Assemble decompression lever (30) as follows:
(a) Install O-ring (32) onto shaft (29).
(b) Install decompression lever (30) on shaft (29) with pin (31).
(c) Insert shaft (29) into cylinder head (15).
(d) Install pinion (28) onto shaft (29) with pin (27).
(4) Assemble rocker arms assembly as follows:
(a) Install clamp (24), nuts (22), and adjusting screws (23).
(b) Install rocker arms (25) onto rocker shaft (13).
f.
INSTALL.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
NOTE
Checking and adjusting clearance is required if either the cylinder, piston, connecting rod,
crankshaft, crankcase or cylinder head has been replaced.
Install new head gasket (22).
Install O-rings (21), shims (20), springs (19), push rod tubes (18), and push rods (16 and 17).
Install cylinder head (15).
Slightly oil threads of head studs (46 and 47).
Install clamp (14).
Install rocker arm assembly. Secure rocker shaft (13) with washers (12), and nuts (11).
Install covers (9 and 10) and lifting eye (8) with lockwashers (7) and nuts (6).
Tighten nuts (6 and 11) alternately and crosswise. Torque nuts (6 and 11) to 26 ft·lbs (35 N·m).
6-16
