TM 10-4320-315-242-35. MAINTENANCE OF ENGINE WIRING HARNESS - (Cont)(2)Tag all terminals and plugs not plainly identified (Figure 2-2).NOTEDepending on specific task to be performed, all wires may not need to be disconnected.(2)Disconnect wiring harness from batteries, cranking motor, cranking motor relay, starter pilot relay, governoractuator, magnetic pickup unit, engine temperature switch, lube oil pressure switch, alternator, fuel shutoffvalve, slave receptacle, and engine block.(3)Disconnect wiring harness from control panel harness at J1.(4)Remove or loosen cable clamps and cable tie down straps.(5)Remove wiring harness.b. INSTALL.(1)Clean battery terminals and other connecting points as required.CAUTIONIncorrect wiring may cause equipment damage. Be sure all connections are made as tagged. Ifin doubt, consult schematic diagram.(2)Connect wiring harness as tagged. Refer to wiring diagram (Figure 2-2) for connection points.(3)Secure wiring harness with cable ties and clamps.c. REPAIR.Repair of wiring harness consists of replacing damaged terminals, pins, and connectors. Refer to 43-0158.2-63
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
