TM 10-4320-315-243-18. MAINTENANCE OF FUEL INJECTION PUMP - (Cont)(d)Rotate front pulley CW until the timing mark (1, Figure 3-14) Is exactly aligned with the referencepointer of timing tool (3) and the piston for No. 1 cylinder is traveling toward TDC compressionstroke.(e)Loosen the three bolts (4, Figure 3-13) that secure injection pump drive gear (7).(f)Operate high pressure hand pump (5, Figure 3-16). With socket on nut (16, Figure 3-13), slowly turnInjection pump shaft CW within the mounting slots of injection pump drive gear (6) until the streamfrom the spill pipe turns to droplets. Then tighten the three bolts (4) that secure injection pump drivegear (6).(g)Check timing by turning front pulley one-quarter turn CCW. Start operating high pressure handpump while turning front pulley slowly CW until stream from spill pipe turns to droplets.(h)Check that the timing mark is aligned with the reference pointer +1 degree. If not aligned, repeatsteps (c) through (g).Figure 3-16. Setting Injection Pump Timing3-37
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
