TM 10-4320-315-10
CHAPTER 2
OPERATING INSTRUCTIONS
PARAGRAPH TITLE
PARAGRAPH
Assembly and Preparation for Use....................................................................................................................................2-6
Emergency Procedures...................................................................................................................................................2-13
Equipment is Not Ready/Available If Column....................................................................................................................2-5
General, Descriptions and Use of Operator’s Controls and Indicators..............................................................................2-1
General, Operation Under Unusual Conditions...............................................................................................................2-12
General, Operator Preventive Maintenance Checks and Service.....................................................................................2-3
Initial Adjustments and Daily Checks ................................................................................................................................2-7
Operating Instructions on Decals and Instruction Plates.................................................................................................2-11
Operating Procedures .......................................................................................................................................................2-8
Operation of Auxiliary Equipment......................................................................................................................................2-9
Operator’s Controls and Indicators....................................................................................................................................2-2
PMCS Procedures.............................................................................................................................................................2-4
Preparation for Movement...............................................................................................................................................2-10
Section I. DESCRIPTION AND USE OF OPERATOR’S CONTROLS AND INDICATORS
2-1 General. This section provides a description and use of operator controls and indicators that are used to operate the
pumping assembly. The operator should become thoroughly familiar with the controls and indicators and with the proper
operating procedures for the pumping assembly.
NOTE
If equipment fails to operate, refer to troubleshooting procedures in Chapter 3.
2-2 Operator’s Controls and Indicators. Table 2-1 contains controls and indicators located on the control panel of
pumping assembly. Table 2-2 contains engine controls and indicators located below the control panel. Table 2-3 contains
pumping assembly fuel controls and indicators. Table 2-4 contains pumping assembly controls and indicators.
Table 2-1. Control Panel Controls and Indicators
Controls or indicators
Function
1
ENGINE VOLTS Meter
Indicates battery condition.
2.
ENGINE TEMPERATURE Gage
Indicates engine oil temperature in F and C.
3
PANEL LIGHTS
Illuminate control panel.
2-1
