4-6. SETUP INSTRUCTIONS Continued

Section III. PREVENTIVE MAINTENANCE CHECKS AND SERVICES - TM-10-4320-310-14_60

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
52

TM 10-4320-310-14 4-6. SETUP INSTRUCTIONS Continued (1) Insert ground cable into slot in ground stud and tighten. (2) Connect coupling to ground rod and install driving stud. Make sure that driving stud seats on ground rod. (3) Drive ground rod into ground until coupling is just above surface. (4) Remove driving stud and install another section of ground rod making sure that it seats on first section. (5) Install another coupling and driving stud. Drive ground rod until new coupling is just above ground surface. (6) Use a minimum of three sections of 3 foot length ground rods. Add additional sections until ground rod has been driven sufficiently deep to provide effective ground. (7) Remove driving stud and top coupling. (8) Connect clamp and ground cable to ground rod and securely tighten screw. 4-7. PRELIMINARY SERVICING AND ADJUSTMENT OF EQUIPMENT SETUP Death or serious injury could occur if fuel is not handled carefully. Use in a well ventilated area away from open flame, arcing equipment, ignition sources, heaters, or excessive heat. Engine must be turned off and cool before refueling. Use proper refueling procedures and equipment to avoid spillage. Do not run engine near open fuel containers. Always store fuel in properly marked containers. DO NOT SMOKE. a. Be sure fuel tank has sufficient fuel. b. With engine level, check oil level. remove oil dipstick (1) and wipe with a lint free cloth. Insert oil dipstick all the way into the engine. Withdraw dipstick. Engine oil should coat oil dipstick to top mark (2). 4-3

Privacy Statement
Press Release
Contact