5-8. TEST INJECTION PUMP

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
102

TM 10-4320-310-14 5-8. TEST INJECTION PUMP This task covers: a. Test INITIAL SETUP Tools Materials/Parts Tool Kit, General Mechanics Automotive Dry cleaning solvent (Item 10, Appendix E) (Item 1, Appendix B) Lubricating oil (Item 6, Appendix E) Testing Device For Injection Equipment (Item 3, Appendix B) Equipment Condition Dial Gauge (Item 3, Appendix B) Para Condition Description Socket Wrench, 30 MM (Item 3, Appendix B) 4-13 Pump housing assembly removed. Special Wrench (Item 3, Appendix B) 4-17 Fuel hose and pressure line removed. Extra Fuel Device (Item 3, Appendix B) General Safety Instructions Well-ventilated area required. TEST: NOTE Perform this test before removal of injection pump and after installation. . Death or serious injury could occur if fuel is not handled carefully. Use in a well- ventilated area away from open flame, arcing equipment, ignition sources, heaters, or excessive heat. Engine must be turned off and cool before refueling. Always store fuel in properly marked containers. DO NOT SMOKE. 1 Connect fuel hose (1) from lift pump to injection pump (4). 2 Make sure the extra fuel device button is not pulled to the extended position. If the button is extended, move the throttle control hand lever to the right and then return the lever to the left to reset the extra fuel button. 5-13

Privacy Statement
Press Release
Contact