TM 10-4320-307-24
2-19
BAIL LIFTING ASSEMBLY REPAIR/REPLACE (CONT).
Use protective gloves while checking cable. Failure to do so could result in personal Injury.
4.
Slide a heavy rag along cable (5) and check for fraying, corrosion, and overall condition. Replace cable if fraying is
found.
Dry cleaning solvent is potentially dangerous. Avoid repeated and prolonged breathing of vapors and skin
contact with the liquid. Do not use near open flame, arcing equipment, or other Ignition source. Always wear
eye protection and protective clothing.
5.
Inspect spreader bar (6) for corrosion, nicks, and burrs. Smooth with crocus abrasive cloth. Clean with dry cleaning
solvent and refinish surfaces. Replace parts if severely damaged.
INSTALL/STOW:
1.
If lifting bail assembly (2) is to be stowed, remove spreader bars and secure to rear of skid assembly (side opposite
pump) using U-bolts provided.
2.
If lifting bail assembly (2) is to remain attached to skid, remove lifting device and allow triple ring (1) to rest on top of
enclosure or container.
2-43
