TM 10-4320-307-244-7TURBOCHARGER(HC3-16)REPAIR(CONT).10. Place bearing housing (2) in special sleeve or short length of suitable diameter brass pipe so that turbine end flange is supported in sleeve. Place clean rags at bottom of sleeve to prevent damage to turbine wheel.11. Position bearing housing (2) and sleeve in arbor press so that press bears on compressor shaft end of shaft and wheel assembly (11) and press wheel assembly (11) from bearing housing (2).12. Remove retaining ring (12) from groove in bearing housing (2).13. Remove heat shield (13) from bearing housing (2).14. Remove outer snap ring (14), oil control ring (15), bearing (16), and inner snap ring (17) from bearing housing (2).15. Remove retaining ring (18) from groove in bearing housing (2).16. Remove oil seal ring (19) and O-ring (20).17. Remove piston ring (21) and slinger (22).18. Remove oil baffle (23).19. Remove thrust ring (24), spacer (25), thrust bearing (26), and inner thrust ring (27).20. Remove snap ring (28) from groove in bearing housing(2) and remove bearing (29) and inner snap ring (30).4-38
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business