TM 10-4320-307-24Section II. MAINTENANCE PROCEDURESINDEXParaParaCamshaft Assembly Inspect/Gear Cover Assembly Repair/Replace ........4-14Repair/Replace.....................................................4-15Injector Repair ............................ ................4-11Connecting Rod and Piston AssemblyLube Oil Pump Assembly Repair .................4-10Replace/Repair.....................................................4-16Pump Assembly Mechanical Seal Repair.....4-4Crankshaft Assembly Replace/Repair......................4-17Pump Assembly Shaft Inspect/Test/Repair..4-5Cylinder Block Inspect/Repair/Replace.....................4-18Skid Repair..................................................4-19Cylinder Head Assembly Repair...............................4-12Speed Increaser Repair...............................4-6Flywheel and Flywheel Housing Repair(Rear Oil Seal) ......................................................4-13Turbocharger Repair (HC3-16).....................4-7Fuel Pump Assembly Repair/Calibrate.....................4-9Turbocharger Repair (T-18A).......................4-84-3GENERALINSTRUCTIONS .Most maintenance instructions in this section will list resources required, personnelrequired, and equipment condition for the start of the procedure. Note the following.a.Resources required are not listed unless they apply to the procedure.b.Personnel required are listed only if the task requires more than one. If PERSONNEL is not listed, it means oneperson can do the task.c.The normal standard equipment condition to start a maintenance task is engine stopped and START/STOP switchset at STOP. EQUIPMENT CONDITION is not listed unless some other condition is required besides the powerbeing off.d.Refer to Appendix D to determine torque requirements when tightening threaded fasteners, unless a specific torquevalue is given in the procedure. Standard torque values given in Appendix D are determined by thread size.4-3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
