3-39 GEAR COVER ASSEMBLY INSPECT/REPAIR.

OIL PAN AND OIL GAUGE BRACKET REPAIR/REPLACE (CONT) - TM-10-4320-307-24_403

GEAR COVER ASSEMBLY INSPECT/REPAIR (CONT)

TM-10-4320-307-24 Pump Assembly (Mainline) Diesel Engine Driven 800 GPM NSN 4320-01-193-3430 Manual
Page Navigation
398

TM 10-4320-307-24 3-39 GEAR COVER ASSEMBLY INSPECT/REPAIR. This task covers: a. Disassembly b. Cleaning/Inspection c. Assembly INITIAL SETUP Tools Equipment Magnet Condition Drill (Item 2, Appendix B) Reference Condition Description Dial indicator (Item 5, Appendix B) Paragraph Alternator drive belt Torque wrench (Item 2. Appendix B) 2-41 removed Tool kit, general mechanic's (Item 1, Appendix B) Paragraph Accessory drive pulley Mandrel (Item 30, Appendix B) 3-30 removed Seal puller (Item 39, Appendix B) Paragraph Fan drive belts removed Materials/Parts 2-48 Paragraph Water pump drive belts Emery cloth (Item 2. Appendix C) 2-50 removed Crocus abrasive cloth (Item 1, Appendix C) Lubricating oil (Item 22, Appendix C) Crankshaft oil seal Suitable guide studs Accessory drive oil seal Soft cloth DISASSEMBLY: 1. Remove vibration damper (1) and pulley (2) as follows: a. Remove one capscrew (3) and washer (4) holding vibration damper (1) and pulley (2) to crankshaft, and install guide stud (5) in its place. CAUTION Do not use hammer or screwdriver to remove the vibration damper. Those tools can cause damage to the damper. b. Remove five remaining capscrews (3) and washers (4) and slide vibration damper (1) and pulley (2) off guide stud (5). c. Remove guide stud (5). 3-151

Privacy Statement
Press Release
Contact