TM 10-4320-307-24
2-52
LUBRICATION OIL FILTER/COOLER SERVICE/REPLACE (CONT).
CLEANING/INSPECTION:
Dry cleaning solvent is potentially dangerous . Avoid repeated and prolonged breathing
of vapors and skin contact with the liquid . Do not use near open flame, arcing
equipment, or other ignition source . Always wear eye protection and protective
clothing.
Death or serious injury could occur if compressed air is directed against the skin. Do not
use compressed air for cleaning or drying unless the pressure is/has been reduced to 30
psi (2.11 kgcm2) or less . When working with compressed air always use chip guards,
eye protection, and other personal protective equipment.
1.
lean gasket material from cooler support and cylinder block.
2.
After removing gasket material, use dry cleaning solvent and dry with compressed air.
3.
Inspect lubrication oil filter/cooler for obvious damage.
NOTE
Notify direct support maintenance for further repair and disassembly.
INSTALLATION:
1.
Install two guide studs in oil cooler support
mounting holes
cylinder block.
2.
Install new oil cooler support gasket over guide
studs.
3.
Install oil cooler assembly (1) over guide studs (2)
and
push it against cylinder block.
4.
Install two oil cooler brace capscrews . Do not
tighten at this time.
5.
Install four support mounting capscrews (3) and
remove two guide studs.
6.
Install two remaining capscrews (4) and tighten all
support capscrews to 35 ft-lbs (45 Nm) torque.
2-216
