TM 10-4320-307-24
2-28
WIRING, GAUGES, SWITCHES, AND INDICATORS TEST/REPAIR/REPLACE (CONT).
NOTE
ALARM RESET and PRESS TO TEST LAMPS
switches are installed as in step 11.
11. Position pushbutton (18) on control panel and secure
using locknut (19) and pushbutton cap (20).
NOTE
LOW SUCTION PRESSURE, HIGH ENGINE
TEMPERATURE, LOW OIL PRESSURE, and
ENGINE OVERSPEED indicators are installed
as in steps 12 and 13.
12. Position indicator (21) on rear of panel. Install
lampholder (22) from front of panel and turn. Tighten
two screws (23) on rear of indicator.
13. Install lens cover (24) and lens (25).
14. Position MODE CONTROL MANUAL/AUTO switch
(26) on control panel and secure using locknut (27).
15. Install cap on MODE CONTROL MANUAL/AUTO knob
(28) on MANUAL/AUTO switch.
16. Install ENGINE/PUMP CONTROLLER switch (29) on
control panel and tighten using locknut (30).
17. Install ENGINE/PUMP CONTROLLER knob (31) on
MODE CONTROL switch and tighten setscrew (32).
2-102
