TM 10-4320-307-24
2-27
BATTERIES, BATTERY BOX, AND BATTERY CABLE ASSEMBLY SERVICE/TEST/REPAIR/REPLACE
(CONT).
2.
Install charging receptacle (22) as follows:
a.
Place gasket (23) and insulation (24) on flange of
charging receptacle (22) and insert receptacle,
terminals first, into hole in bracket (25).
b.
Secure charging receptacle (22) to bracket (25)
using four screws (26) and lockwashers (27). Be
sure that lanyard eyelet (28) is secured to bracket
by one of the screws.
c.
Using two screws (29) and lockwashers (30),
secure cables (15 and 19) to terminals (31 and 32)
of charging receptacle (22).
3.
Install batteries as follows:
Serious injury could occur from the careless
handling of storage batteries or battery
electrolyte (acid). If acid is splashed on the
skin, wash the affected area immediately
with plenty of clean water. If acid is
splashed in the eyes, wash immediately with
plenty of clean water and get medical
attention.
NOTE
The 6TN and 6TL batteries can be mixed or
matched. However, maintenance-free batteries
cannot be mixed or matched with military
batteries.
a.
Place batteries (33) into battery box (1) so that
terminals (34) are located as shown in figure.
Avoid making contact across the battery terminals.
This can result in severe arcing which could cause an
explosion resulting in bodily injury.
b.
Install hold-down bars (35) using four wing nuts (36).
2-91
