SECTION III. OPERATION UNDER USUAL CONDITIONS

Operator preventive Maintenance Checks and Services for-the 350 GPM pumping Assembly. (continued)

TM-10-4320-226-14 Water Pumping Assembly Diesel Engine Driven Wheel Mounted 350 Gallons Per Minute (GPM) 275 Foot Head Models: 350 PAW Manual
Page Navigation
32

TM 10-4320-226-14 SECTION III. OPERATION UNDER USUAL CONDITIONS 2.3 ASSEMBLY AND PREPARATION FOR USE. Upon reaching the operating area where pumping assembly is to be used, prepare the equipment for use as follows: a. Prepare a level site. b. Be sure all sides accessible. c. When connected to (1) (2) (3) (4) (5) (6) (7) (10) Position the suction lift of the equipment and all fittings and controls are easily towing vehicle, perform following: equipment as close as possible to the water source. Keep as low as possible. Remove pins (figure 2-3, 1 and 2) and extend trailer support legs (3) as far as possible. Reinstall pins (1 and 2) to secure trailer support Release pintle (4) and disconnect pumping assembly legs (3). from towing vehicle (5) . Secure wheels Refer to data positioned as — (6). plate and ensure two fuel selector valves (7) are follows: Fuel tank as source to TANK Auxilary supply as source to Remove quick release shaft (10) inward to Insert quick release position. pins (8 and 9) FUEL AUX from trailer tongue and slide tongue non-extended position and align holes. pins (8 and 9) and secure tongue in non-extended 2-11

Privacy Statement
Press Release
Contact