TM 10-4320-226-14
5.5.7 Injection Nozzle Maintenance.
This task covers:
5.5.7.1 Removal
5.5.7.3 Installation
5.5.7.2 Repair
INITIAL SETUP
Tools
General Mechanics Tool Kit (appendix B,
Section III, Item 1)
Injector Pump Tester gauge (appendix B,
Section III, Item 9)
Equipment Conditions
Equipment shut down, refer to
paragraph 2.5.1.2 or 2.5.2.2.
Injection nozzle removed,
General Instructions
To prevent rolling or
not work on equipment
securely stabilized.
sliding, do
that is not
Do not smoke or use open flames
around fuel.
Ensure container is
used to catch fuel and fuel is
disposed of properly.
Do not work on equipment without
following standard shop safety
precautions.
paragraph 5.5.3 step a.
Figure 5-7.
Injection NoZzle Maintenance.
To prevent rolling or sliding, do not work on equipment that is not
securely stabilized.
Ensure both wheels are secure.
Do not smoke or use open flames around fuel.
Ensure container is used to
catch fuel and fuel is disposed of properly.
Failure to obey these warnings may result in personal injury or death.
5.5.7.1 Removal.
a.
Unscrew cap (figure 5-7, 1) and remove body (2), needle (3), and intermediate
piece (4).
5-21
