TM 10-4320-226-145.5.5 Injection Pump Maintenance.This task covers:5.5.5.1 Removal5.5.5.2 InstallationINITIAL SETUPToolsGeneral Mechanics Tool Kit (appendix B,Section III, Item 1)Material/PartsLockwashers (TM 10-4320-226-24P)Gaskets (TM 10-4320-226-24P)Preformed packing (TM 10-4320-226-24P)Tags (appendix E, Section II, Item 12)PersonnelRequired2EquipmentConditionsEquipment shut down, refer toparagraph 2.5.1.2 or 2.5.2.2.Throttle Control Rod removed, paragraph4.11. (Non regulated pump only).EquipmentConditions(continued)Actuator removed paragraph 4.14.6(Regulated pump only).Engine at TDC, paragraph 5.5.9.Fuel lines removed from regulatorpump (paragraph 4.10.16).GeneralInstructionsTo prevent rolling or sliding, donot work on equipment that is notsecurely stabilized.Do not smoke or use open flamesaround fuel.Ensure container isused to catch fuel and fuel isdisposed of properly.DO not work on equipment withoutfollowing standard shop safetyprecautions.5.5.5.1To prevent rolling or sliding, do not work on equipment that is notsecurely stabilized.Ensure both wheels are secure.Do not smoke or use open flames around fuel.Ensure container is used tocatch fuel and fuel is disposed of properly.Failure to obey these warnings may result in personal injury or death.Do not drop cap screws or washers into timing cover.Failure to obeythis caution may cause equipment damage.Upon removal of any fuel line, hose or fittings, plug all openports and place caps over all fuel lines and hoses to preventcontamination of fuel system.Removal.a.Place clean shop rag inside gear housing, so that rag is against fuelinjection pump drive gear (figure 5-5, 1) and prevents objects from fallinginto gear hose.b.Remove two of three bolts (2), washers (3) and spacers (4) that secure fuelinjection pump drive gear (1) to fuel injection pump (5).5-16
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business