TM 10-4320-226-144.10.16.1 Removal.To prevent rolling or sliding, do not work on equipment that is notsecurely stabilized.Ensure both wheels of equipment have chocks that aresecure.DO not smoke or use open flames around fuel.Ensure container is used tocatch fuel and fuel is disposed of properly.Failure to obey these warnings may result in personal injury or death.Some models have clamps.a.Set both source selector valves (figure 4-20, 1) to the off position.b.Disconnect fuel supply line (2) as follows:(1) Tag and disconnect fuel supply line connection (3) at source selector valve(1) on fuel tank (4).(2) Tag and disconnect fuel supply line connection (5) at water separator (6)inlet fitting.Disconnect clamps as required.(3) Remove fuel supplyc.Disconnect fuel feed(1) Tag and disconnectdischarge fitting.(2) Tag and disconnectlinepumpfuelfuel(2) and cover openings.line (7) as follows:pump line connection (8) at water separator (6)pump line connection (9) at adapter (10).(3) Remove fuel pump line (7) and cover openings.(4) Remove adapter (10).(5) Remove banjo bolt (11), washer (12), banjo connector (13) and washer (14)from fuel pump.Cover openings.d.Tag and disconnect fuel filter line (15) as follows:(1) Remove banjo bolt (16), washer (17), banjo connector (18) and washer (19)from fuel pump.(2) Remove banjo bolt (20), washer (21), banjo connector (22) and washer (23)from fuel filter inlet.(3) Remove fuel filter line (15) and cover openings.e.Tag and disconnect fuel filter outlet (figure 4-21, 1) as follows:(1) Remove banjo bolt (2), washer (3), banjo connectorfuel filter.(2) Remove banjo bolt (6), washer (7), banjo connectorfuel injector inlet.(3) Remove filter outlet line (1) and cover openings.(4) and washer (5) from(8) and washer (9) from4-44
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
