TM 10-4320-226-14
4.10.13.1 Removal.
Do not work on starter assembly with negative battery terminal connected.
To prevent rolling or sliding, do not work on equipment that is not securely stabilized.
Ensure both wheels are secure.
Failure to obey these warnings may result in serious injury.
a.
Remove bolt (figure 4-17, 1), lockwasher (2) and negative (-) battery cable (3).
b.
Remove nut (4). Tag and disconnect wire (5).
c.
Remove nut (6) and washer (7).
d.
Tag positive (t) battery cable (8) and wires (9).
e.
On Model 350 PAWN only, remove nut (11), washer (12) and wires (13). Tag wires.
f.
Remove remaining two bolts (1) and lo&washers (2) that secure starter (10) to engine.
g.
Carefully separate starter (10) from engine.
4.10.13.2 Installation.
a.
Position starter (10) on engine so that drive gear mates with teeth on flywheel.
b.
Install two lock-washers (2) and bolts (1) in starter leaving bottom bolt (1) to connect negative battery cable (3).
C.
Install wires (9), positive (t) battery cable (8), washer (7), and nut (6). Remove tags.
d.
Install wire (5) and nut (4). Remove tag.
e.
Install negative (-) battery cable (3), lockwasher (2), and bolt (1).
f. Tighten bolt (1).
g,
On Model 350 PAWN only, install wires (13), washer (12) and nut (11). Remove tags.
4-38 Change 2
