TM5-4930-230-13
e. Assembly. (figure 5-4)
(1) Install identification plate (34) with screws (33).
(2) Install rod (31) and nut (32).
NOTE
Before installing new filter elements, ensure that O-ring in each end of
each element is properly seated in its groove. Lubricate the O-rings with
GAA grease ((tern 2, App E) to prevent displacement during element
installation.
(3) Install filter elements (30) and canisters.
(4) Attach band clamp (28).
(5) Install canister retainer (27), washer (26), and wingnut (25).
(6) Install pressure vent valve (23) and packing (24) in tank cover.
(7) Install packing (22), cover (21), and coupling halves (20), and fasten with bolts (17), washers
(18), and nuts (19).
(8)
(9)
(10)
(11)
Install differential pressure gage (16), washers (14 and 15), and screws (13).
Install elbows (11 and 12) and tube assemblies (10).
Insert float ball (8) into sight gage (7) and install with gasket (9), washers (6), and screws (5). -
Install elbow (4), drain cock (3), hose (2), and clamp (1),
f. Installation.
(1) Install elbows at inlet and discharge holes of filter/separator (figure 5-3).
(2) Attach filter/separator to A-frame with screws, washers, and nuts.
(3) Connect inlet and discharge hoses.
(4) Close drain cock.
g. RF Filter Test. (figure 4-24)
(1) Disconnect power cable (J2).
(2) Unscrew and remove junction box cover with O-ring.
(3) Tag and remove wires from Terminals, 4, 5, and 6.
(4) Remove four screws from top cover of RF filter exposing Terminals 1,2, and 3.
5-10
Change 8
