Figure 1-5. Filter /separator flow chart.

Figure 1-4. Pump and engine assembly, three-quarter view

TM-5-4930-228-14 Tank and Pump Unit Liquid Dispensing for Truck Mounting (Highland Industries Model 2000) FSN 4930-877-8678 Manual
Page Navigation
8

drain cock. Solid contaminants are deposited in the drain as free water. Clean product builds up in the elements. The emulsified or entrained water shell and is pumped to the hose reels. Refer to coalesces within the elements and settles to the deck figure 1-5 for the flow of the pumped product. plate where it is removed periodically, through the Figure 1-5. Filter / 1-8. Tabulated Data a. Identification. The tank and pump unit has three major identification and instruction plates, (1) Engine manufacturers identification plate. This plate is located on the top front of the engine shroud. It specifies the model, serial number, size, rpm, specification number, net continuous brake horsepower, and date of manufacture, (2) Tank and pump unit operation data plate. Located on the lower left frame, the plate specifies pre-operation procedures, engine starting and stopping instructions, and pumping instructions. separator flow chart. (3) Tank identification plate. This plate is located on the top-center, rear of each of the two tan ks. It specifies capacity, Federal stock number, serial number, manufacturer, date of manufacture, contract number, weight (empty), and note of fuel weight (in pounds per gallon). b. Operator’s Tabulated Data. (1) Capacities: Engine fuel tank . . . . . . . . . . . . . 1 gal. (gallon) Engine air cleaner . . . . . . . . l gal. Engine crankcase . . . . . . . . 1 qt. (quart) Tank . . . . . . . . . . . . . . . . 600 gal. 1-8

Privacy Statement
Press Release
Contact