Section II. OPERATOR/CREW PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)

PREVENTIVE MAINTENANCE CHECKS AND SERVICES (Continued) - TM-5-4320-306-10_30

TM-5-4320-306-10 Pump Unit Centrifugal Hoseline Diesel-Engine-Driven 600 GPM at 100 PSI Model US612ACD-1 NSN 4329-01-193-3429 Manual
Page Navigation
22

TM 5-4320-306-10 Section II. OPERATOR/CREW PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) 2-2. GENERAL a. Before you operate. Always keep in mind the CAUTIONS and WARNINGS. Perform your before (B) PMCS. b. While you operate. Always keep in mind the CAUTIONS and WARNINGS. Perform your during (D) PMCS. c. After you operate. Be sure to perform your after (A) PMCS. d. If your equipment fails to operate. Troubleshoot with proper equipment. Report any deficiencies using the proper forms. See DA PAM 738-750. 2-3. PREVENTIVE MAINTENANCE CHECKS AND SERVICES a. Table 2-2 lists the preventive maintenance checks and services which shall be performed at specified intervals by the operator/crew. b. Item numbers are assigned to each check or service task. These numbers are to be used as a source of item numbers for the TM Number column on DA Form 2404, Equipment Inspection and Maintenance Worksheet, in recording results of PMCS. c. The service intervals are divided into four categories: B Before Operation, D During Operation, A-After Operation, and W-Weekly. A dot (e) is placed in the interval column for each check or service. If the same check or service is made in two or more intervals, a dot is placed in each applicable column. d. The ITEM TO BE INSPECTED column lists the item to be checked or serviced. This column is combined with the PROCEDURE column. e. The PROCEDURE column describes the procedure by which the check or service is to be performed. Illustrations are included to assist in locating that part of the equipment requiring the check or service. When instructions for removal of assemblies or equipment are required in order to perform PMCS, they are listed and illustrated in the PROCEDURE column. f. The EQUIPMENT IS NOT READY/AVAILABLE IF: column contains the basis for classifying the equipment as not ready/available because it is unable to perform its primary mission. An entry in this column will: (1) Identify conditions that make the equipment not ready/available for readiness reporting purposes. (2) Deny use of the equipment until corrective maintenance has been performed. g. Leakage definitions for operator/crew PMCS shall be classified as follows: Class I Seepage of fluid (as indicated by wetness or discoloration) not great enough to form drops. 2-9

Privacy Statement
Press Release
Contact