TM 5-4320-302-146-14.DRIVE SHAFT (CONT)Location/ItemActionRemarks21. Connecting rodPosition base of connecting rod with upper big-end bearing installed onto crankpin oncrankshaft.22. Bearing capa.Install with lower big-end bearing in place. Check matchmarks made during removalto make sure bearings are installed in same connecting rods from which they wereremoved.b.Install pins.c.Make sure that hex bolts are new and the same type as were removed fromconnecting rods. Install and tighten alternately and evenly to 22.13 ft lb (30 N.m)torque with socket wrench. Using torque gage, tighten bolts three additional 30degree increments.6-96
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
