TM 5-4320-302-146-14.DRIVE SHAFT (CONT)Location/ItemActionRemarksCLEANING/INSPECTIONWARNINGSevere burns, illness, or death may result if personnel fail to handle diesel fuel oil properly. Observe thefollowing precautions:Do not inhale vapor.Work in a well-ventilated area.Do not use near open flame, sparks, or excessive heat.Death or severe injury might result when compressed air is used to blow dirt from skin or clothing. Airentering body openings is extremely dangerous. Compressed air used for cleaning shall not exceed 100psi (690 kPa). Use goggles or face shield for eye protection. Do not direct airstream against skin.8.All driveClean with VV-F-800 diesel fuel oil and dry withshaft componentslow pressure compressed air.9.Drive shafta.Inspect for excessive wear, damage, rust, corrosion, or stripped or broken gearteeth. Replace if necessary. Measure diameter A which should be 1.4550 to 1.4555inches (36.955 to 36.971 mm). Replace drive shaft if diameter is smaller.b.Inspect hex bolt and spring washer for damage, rust, corrosion, or stripped threads.Replace if necessary.c.Inspect large and small spacer rings for damage, rust, corrosion, or excessive wear.Replace if necessary.10.Ball bearingInspect for smooth operation, excessive wear, damage, rust, or corrosion. Replace ifworn, damaged, rusted, or corroded. Measure ball bearing bore. Bore should be 1.4550to 1.4555 inches (36.955 to 36.971 mm). If bore is larger than 1.4555 inches (36.971mm), replace ball bearing.6-90
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business