TM 5-4320-302-14
5-4. PUMP AND BEARING HOUSING ASSEMBLY (CONT)
Location/Item
Action
Remarks
WARNING
Make sure that hoists and other lifting equipment are in
good repair and of sufficient capacity to safely handle loads
without injury to personnel or damage to equipment. Se-
curely attach lifting equipment. Before lifting, be sure load
is balanced.
3. Pump and
a. Position a suitable lifting device equipped
Spread slings on
bearing hous-
with a spreader bar and slings over pump and
spreader bar so that
ing assembly
bearing housing assembly. Attach slings
slings hang vertically
around assembly and put tension on slings.
when attached to
Make sure assembly is properly supported.
assembly.
b. Remove nuts and lockwashers.
4. Pump and
a. Remove cap screws
bearing hous-
and lockwashers.
ing assembly
b. Lift and remove
pump and bearing
housing assembly
from skid and
engine assembly,
and lower onto
blocks on a
stable, level work
platform.
5-8
