TM 5-4320-302-14
4-21.
AIR CLEANER, AIR INTAKE TUBES, ELBOWS, AND RAIN CAP (CONT)
Location/Item
Action
Remarks
REPAIR
11. Air cleaner
Repair minor dents, abraded areas, rust, or cor-
assembly, rain
rosion. Repair or replace severely worn, damaged,
cap, clamps,
or rusted components. Clean or replace element(s)
and element(s)
if element(s) cannot be cleaned properly.
12. Elbows, tubes,
Do not attempt to repair brittle, cracked, or
and clamps
deteriorated rubber components. Replace as
necessary. Repair rust or corrosion on tubes and
elbows. If damaged severely, replace components.
13. Air cleaner
Do not attempt to repair brittle, cracked, or
service indi-
deteriorated hoses. Replace as necessary. Do not
cator hose
attempt to repair rusted or corroded clamp;
assembly and
replace clamp.
hose clamp
INSTALLATION/REPLACEMENT
14. Air cleaner
Install in back of control panel in accordance with
service indi-
paragraph 4-16.
cator hose
assembly
15. Air cleaner
Install on skid-mounted air cleaner clamps with
Rain cap on stack.
assembly and
inlet stack up. Tighten clamps securely. Install
rain cap
rain cap on stack and tighten clamp under rain cap.
16. Cup assembly
Install on air cleaner. Tighten cup assembly clamp
and cup assem-
securely.
bly clamp
17. Lower air
Install on air cleaner. Tighten hose clamp securely.
inlet elbow
18. Air inlet lower
Install. Tighten hose clamps securely.
tube, upper air
inlet elbow, and
air inlet upper
tube
4-109
