TM 5-4320-300-14
4-35. OIL LINES, FITTINGS, AND OIL PRESSURE GAGE TUBE ASSEMBLY (CONT)
Location/Item
Action
Remarks
2.
Oil pressure
Remove tube assembly from elbow on back of
gage tube
oil pressure gage. Cut tie wraps as necessary to
assembly
remove tube. Remove tube end from female
pipe tee on cylinder block.
INSTALLATION
3.
Governor oil
Position and loosely connect governor oil line
line
at elbow fitting and at lower fitting. Tighten
oil line securely at both fittings.
4.
Oil pressure
Install male pipe thread end of hose into female
gage tube
pipe tee on cylinder block. Tighten securely.
assembly
Using tie wraps, attach tube to main wiring
harness. Run tube to back of oil pressure gage
located in control panel assembly. Thread hose
fitting onto elbow on pressure gage. Bleed air
from the tube assembly by cranking the engine.
Tighten tube swivel securely on elbow when
bleeding is completed.
4-142
